Pattern Dress Design

About Pattern Dress Design Android App

The pattern of sewing is a piece of cloth or paper used as an example to make a shirt, when a cloth is cut. The piece of cloth or paper follows the Costume Design of a particular body shape and model.

The template consists of:
-The upper body pattern, from the shoulders to the waist, is usually called the body pattern of the front and back.
-The bottom pattern, from waist to knee or to ankle. Or commonly called the basic pattern of the face and back of the skirt.
-The arm pattern, from the upper arm or the lowest shoulder to the elbow or wrist, commonly called the arms base.
-Adapula upper body pattern with a lower body pattern that becomes one commonly called the basic pattern of dress or dress.

Take body size
At the time of taking the measurement, the model or the person being measured must stand upright so that the correct size is taken.
Previously tie a small tire cord or tire with a width of no more than 2cm at the waist as the upper and lower body limits. Pay close attention to where the rope is right in place and not winding.Part Body in the measured:

Neck circumference is measured around the lower neck margin, by placing the index finger on the neck buckle or measured and added 1 cm
The body circumference is measured around the top of the largest body, through the top of the chest, measured fitting plus 4 cm or by dividing 4 fingers.
Waist circumference is measured around the waist fitting.
-Height is measured from under the waistband to the pelvic boundary.
-Bring is measured around the pelvis or lower body of the largest, measured fit, then added 4 cm or 4 fingers.
-Length The back is measured from the back of the neckline protruding below the waistband.
-Reading width measured from the back neck vertebra that protrudes down 9cm then measured flat from left to right border of the arm.
-The sides length is measured by rifling under the armpits, then measured from the bottom to bottom limit of the waistband reduced by 2 to 3 cm
-The face length is measured from the curve of the neck in the center of the face down to the bottom under the waistband.
-The face width is measured 5 cm below the center of the center of the face, then measured flat from the left to right border.
-The height of the chest is measured from beneath the waistband perpendicular up to the top of the breasts.
Shoulder Width is measured from the curve of the neck on the shoulder or the highest shoulder to the lowest point of the shoulder.
-The size of the Test or the size of the control, measured from the center of the face under the oblique tire through the top of the chest to the top of the arm, continues to slip backwards until the center of the rear is under the tire.
- The length of the facial skirt, side and back are measured from the bottom of the tire to the desired length.
The arm circumference is measured around a sleeveless arm and added 4 cm for the arm hole to be attached to the arm.
- The length of the short sleeve is measured from the top of the arm down to about 3 cm above the elbow.
Long sleeve length is measured from the top of the arm down to the wrist.
-The length of the circumference of the wrist circumference is measured in circular wrists plus 3 cm.