Ripped Jeans Design Ideas

About Ripped Jeans Design Ideas Android App

Ripped Jeans Design Ideas

Provides a wide range of Ripped Jeans design ideas that are inspirational

How to Make Ripped Jeans

With the right steps, ingredients, and patience, you can make Ripped Jeans easily and quickly.

1. Choose your denim

The first step, obviously, is picking out which pair of jeans you want to rip. Tight and skinny, or boyfriend style? Black, white, or blue? High-waisted or mid-rise? We find it’s best to do a few trial runs with either a pair of jeans you don’t really wear anymore.

If you want your jeans to look extra-worn, wash them a few times in hot water and a little bleach before you get started. If not, read on!

2. Gather your supplies to distress and rip

To really make jeans look authentically ripped, it pays to distress them a bit before you start cutting the holes. To do this, you’ll want to grab some sandpaper or a paint-removing block, steel wool, and a pumice stone. For the holes, use a pair of super-sharp small scissors, an X-Acto knife, or a box cutter. We like to use a piece of cardboard or a small wooden block inside the pant legs so you don’t alter the back of the jeans—unless you want to.

3. Put your jeans on to mark

Use a pen, chalk or a safety-pin to denote exactly where you want your rips and/or distressed areas. You might want to grab a ruler, too. It’s key do this while you’re standing.

4. Start distressing

Lay the jeans flat and start rubbing your marked areas with your sandpaper, steel wool, and the pumice stone until the denim starts to really thin out and look worn. Obviously, the time it takes to do this step depends on the thickness of your jeans. If you really want to go for it in the knee or butt area, tape some sandpaper to the floor, put the jeans back on, and slide around on the paper.
what not to wear to work

5. Start making your holes

After your jeans are sufficiently distressed, take your scissors or knife and use the edge (not the tip) to start horizontally scraping the area where you want your rips to be. If you don’t want holes all the way through, scrape enough that you start to see the white horizontal threads beneath the denim’s surface. Once you’re there, you can start using a tweezer to fray the threads. If skin is what you’re after, start cutting the distressed areas with your knife or scissors.