Turning Time

About Turning Time Android App

Turning Time is now 6 Apps in one.

TURNING TIME: Calculates the number of passes and amount of time it takes to remove material when turning. It will also converts diameters, lengths, speeds and feeds from inch to metric and metric to inch. To use Turning Time enter the start diameter, finish diameter and length of cut. Next, enter your cutting parameters and press the Calculate button. Turning Time will convert your inch or metric data and display the number of passes, the time required to remove the material, amount of material removed, the removal rate, the maximum and minimum RPM and maximum IPM and MMPM feedrate. Also can set Max RPM (G50).

FACING TIME: Calculate the time it takes to face a part. Shows material removal rates, RPM G50 is reached. convert inch to metric and vise versa.

TRUE POSITION: Will calculate the true position of a hole and show the MMC.

Ra FINISH: Calculate the surface finish you will get with a known corner radius and feedrate/step over. Also shows the scallop height.

DRILL TIME: Calculate the time to drill a number of holes. Show the RPM and Feedrate in IPM. Show the drill point length. Also shows the amount of material removed and the material removal rate. Create and send Lathe Gcode part program.

3 POINT CIRCLE: If you know the XY position of 3 points the app will calculate the center of the circle and the diameter.

TAPPING: Calculate time to tap holes, RPM and Feed per Minute and per Rev.Inch and Metric. Enter the percent of thread and the app will tell you the drill size.